Differences

This shows you the differences between two versions of the page.

--- start:tetraaustria:prepare_svxlink [2020/07/11 06:12]
oe1kbc
+++ start:tetraaustria:prepare_svxlink [2020/07/11 06:42]
oe1kbc
@@ Line 3: / Line 3: @@
   * SD-Karte (16 GByte empfohlen) mit Raspberry "Raspberry Pi OS (32-bit) Lite" vorbereiten.
     * Link: [[https://www.raspberrypi.org/downloads/raspberry-pi-os/|https://www.raspberrypi.org/downloads/raspberry-pi-os/]]
+  * SSH Terminal starten
+  * Grundkonfiguration
+    * //**sudo apt-get upgrade**//
+    * //**sudo apt-get update && sudo apt-get install g++ libsigc++-2.0-dev libgsm1-dev libpopt-dev tcl-dev libgcrypt20-dev libspeex-dev libasound2-dev make alsa-utils git cmake libqt4-dev libopus-dev opus-tools libcurl4-gnutls-dev libjsoncpp-dev**//
+    * Fragen jeweils mit "Y" (bzw. "J" wenn auf deutsch installiert) beantworten
+    * Dieser Vorgang dauert länger. Je nach INTERNET Zugangsgeschwindigkeit
+  * User für svxlink-Echolink anlegen
+    * //**sudo useradd -c 'Echolink user' -G audio -d /home/svxlink -m -s /sbin/nologin svxlink**//
+  * SVXLINK Installation aus dem GITHUB
+    * //**git clone https://github.com/sm0svx/svxlink.git**//
+    * //**cd svxlink**//
+    * //**mkdir src/build**//
+    * //**cd src/build**//
+    * //**cmake -DUSE_QT=OFF -DCMAKE_INSTALL_PREFIX=/usr -DSYSCONF_INSTALL_DIR=/etc -DLOCAL_STATE_DIR=/var -DCMAKE_BUILD_TYPE=Release ..**//
+    * //**make**//
+    * //**sudo make install**//
+  * SVXLINK //**/etc/svxlink/svxlink.conf**// anpassen